addressalign-toparrow-leftarrow-rightbackbellblockcalendarcameraccwcheckchevron-downchevron-leftchevron-rightchevron-small-downchevron-small-leftchevron-small-rightchevron-small-upchevron-upcircle-with-checkcircle-with-crosscircle-with-pluscrossdots-three-verticaleditemptyheartexporteye-with-lineeyefacebookfolderfullheartglobegmailgooglegroupshelp-with-circleimageimagesinstagramFill 1linklocation-pinm-swarmSearchmailmessagesminusmoremuplabelShape 3 + Rectangle 1ShapeoutlookpersonJoin Group on CardStartprice-ribbonShapeShapeShapeShapeImported LayersImported LayersImported Layersshieldstartickettrashtriangle-downtriangle-uptwitteruserwarningyahoo

Using the Kinect as a Scanner, Take Two; and Octoprint

Alex will show his new-and-improved Kinect scanner setup, and Brian will discuss his experiences with Octoprint.  I will bring some molds I printed.  Feel free to bring your successes (to brag) and your failures (for helpful suggestions).

We will be meeting at Generator for the first time!  We hope to meet on the 2nd Thursdays of each month over the summer.

Note that I will be giving a short course on "Introduction to 3D Printing at Generator" on the 14th.  If you have courses you would like to teach, be sure to get in touch with the Generator staff ([masked])


Join or login to comment.

10 went

Our Sponsors

People in this
Meetup are also in:

Sign up

Meetup members, Log in

By clicking "Sign up" or "Sign up using Facebook", you confirm that you accept our Terms of Service & Privacy Policy