|Sent on:||Thursday, November 22, 2012 1:10 PM|
Component failure on the KVM board could cause a leak. Something shorting out on an op amp or one of the matrix switching driver chips. Pure conjecture on my part....
interesting trey. what causes a voltage leak? i discovered that its not the faulty server. if i pushed any key while viewing any server, it rebooted all. & occurred w/ greater consistency too. kvm has a 9V ac power outlet which i unplugged but looks like its powered thru the kvm cable still, so i unplugged all servers & now its finally behaving well again.no clue what causes it. see that i have to truly reboot it to fix though.
Please Note: If you hit "REPLY", your message will be sent to everyone on this mailing list ([address removed])
This message was sent by mowgli ([address removed]) from Dallas Open Source Saturday.
To learn more about mowgli, visit his/her member profile
Set my mailing list to email me As they are sent | In one daily email | Don't send me mailing list messages
Meetup, PO Box 4668 #37895 New York, New York[masked] | [address removed]