What we're about

Learn the basics of 3D Printing! Join us for classes on how to get started in 3D printing! Design and print your own models once you master the basics!

-Learn how to set the 3D printer up correctly and avoid common problems

-basic and advanced troubleshooting to make your designs better

-Learn how to use Blender and Tinkercad!

-Optimize your creations for printing!

-set up an online merchant account and share your stuff with the world!

Print table size is 30cm x 30cm x 30cm

Most of my prints are $3.00 for material and $5.00 per hour of print time. Here is an example: 3x Elco PT boats would be 80 minutes of print time. $6.60 + $3.00 so to print my .STL for the Elco PT boats would be $9.60

Custom prints are the same at $3.00 for material and $5.00 per hour of print time. I have to put a limit of four hours for this pricing on any single print. A print that takes longer than four hours can be done, I just need to adjust pricing.

*There is a size limit and a time limit on prints. As time and money permit, printing capacity will be increased.

Past events (7)

Introduction to Cruel Seas "Sink the Greif!"

Cruel Seas 3d print and game

Introduction to Cruel Seas "Sink the Greif!"

Cruel Seas 3d print and game

Introduction to Cruel Seas "Sink the Greif!"

Cruel Seas 3d print and game

Introduction to Cruel Seas "Sink the Greif!"

Cruel Seas 3d print and game

Photos (38)