Introduction of RaspberryPi sensor-actuator interfacing board

This is a past event

14 people went

Munich Maker Lab

Baierbrunner Str. 28 · München

How to find us

Going in through the main gate of Baierbrunner Str. 28, head into the building on the left hand side, and down in the basement. Take a right turn, and you'll find the Lab a few meters down the hallway, on the left side.

Location image of event venue



Dear robotics enthusiasts,

As usual, this meetup will be split in two parts. At the beginning I would like to introduce our new board which could be used to interface Raspberry Pi with different kind of sensors and actuators.

This board is generic enough to build for exampe Raspberry Pi controlled ground vehicles or quadcopter. I will use our A20 ground vehicle ( and one motor/propeller from Mikrokopter ( to illustrate applicability of the board.

The second part will be left for discussions where you can ask your questions show your work and exchange experience with other robotics enthusiasts.

Hope to see a lot of you there,