addressalign-toparrow-leftarrow-rightbackbellblockcalendarcameraccwcheckchevron-downchevron-leftchevron-rightchevron-small-downchevron-small-leftchevron-small-rightchevron-small-upchevron-upcircle-with-checkcircle-with-crosscircle-with-pluscrossdots-three-verticaleditemptyheartexporteye-with-lineeyefacebookfolderfullheartglobegmailgooglegroupshelp-with-circleimageimagesinstagramlinklocation-pinm-swarmSearchmailmessagesminusmoremuplabelShape 3 + Rectangle 1ShapeoutlookpersonJoin Group on CardStartprice-ribbonShapeShapeShapeShapeImported LayersImported LayersImported Layersshieldstartickettrashtriangle-downtriangle-uptwitteruserwarningyahoo

Re: [gctechspace] hexacopter done

From: Ing. Walter H.
Sent on: Friday, November 30, 2012 8:41 PM


On[masked]:22, David B wrote:
Hey guys!

I forgot to post to the list after my dodgy hexacopter build was completed, so here's a pic of the 1m diameter beast:

Sticky tape, cable ties and a few rivets here and there. Weighs around 3kg with batteries!

Here's two funny videos of me learning to fly at the park. This one gets some nice height on it, and then just lots of bouncing around:
And just as I was getting the hang of flying a wire wiggled loose and the thing went nose first into the ground:

All quite fun! 

Now that I have the parts I think I'll build a new lighter/smaller frame to get slightly longer flight time out of it. 

Please Note: If you hit "REPLY", your message will be sent to everyone on this mailing list ([address removed])
This message was sent by David B ([address removed]) from Gold Coast Techspace.
To learn more about David B, visit his/her member profile
Set my mailing list to email me As they are sent | In one daily email | Don't send me mailing list messages

Meetup, PO Box 4668 #37895 New York, New York[masked] | [address removed]

Our Sponsors

People in this
Meetup are also in:

Sign up

Meetup members, Log in

By clicking "Sign up" or "Sign up using Facebook", you confirm that you accept our Terms of Service & Privacy Policy