Location visible to members
We will be learning the basics of using the FormLabs: Form 2 resin based SLA printers including, basic printer maintenance and hardware operation, and software operation. Duration should be approximately 60 minutes.
What is SLA?
PreForm (Slicing Software) Overview
Resin Cartridge/Tank Changeover
*Pre-requisite - Prefer that you have some knowledge/prior experience with FDM or have taken 3D Printer Training: Basics course.
Your trainer is: Richard Venzon. You can contact Richard through the Meetup Messages system or Slack. If you are having trouble contacting Richard, please comment below.
***Payment online is required no later than 24 hours before the start of the session ($35 includes GST). If you cannot pay online contact us to make alternate arrangements prior to the training session. If you are unable to attend the training and do not attempt to contact the trainer at least 24 hours prior to the start of the training, you will be liable for the full cost of the training. Exceptions will be made under reasonable circumstances.