125 Adelaide St. 3rd Floor, Winnipeg, MB
Payment online is required no later than 24 hours before the start of the session. Typically you can arrange to pay by credit card or cheque during the week, or using the PayPal system. If you are unable to attend the training and do not attempt to contact the trainer at least 24 hours prior to the start of the training, you will be liable for the full cost of the training. Exceptions will be made under reasonable circumstances.
Your trainer is: John Haché. You can contact John through the Meetup Messages system. If you are having trouble contacting John, please comment below.
We will be learning the basics of using the Makerbot and uPrint 3D Printers, including adding soluble and non-soluble support materials, basic printer maintenance and hardware operation, and software operation.
Rafts and Adhesion
ABS vs PLA
Refunds are not offered for this Meetup.