3D Printer Training: Form 2

Are you going?

4 spots left


Every 4th Thursday of the month


North Forge Fabrication Lab

125 Adelaide St. 3rd Floor · Winnipeg, MB

How to find us

125 Adelaide is the building directly across from Canadian Footwear. We are on the 3rd floor. Parking is free on the street after 5:30pm.

Location image of event venue


We will be learning the basics of using the FormLabs: Form 2 resin based SLA printers including, basic printer maintenance and hardware operation, and software operation. Duration should be approximately 90 minutes.


What is SLA?


Resin Types

Printer Components


PreForm (Slicing Software) Overview



Resin Cartridge/Tank Changeover

Cleanup Procedures

*Pre-requisite - Prefer that you have some knowledge/prior experience with FDM or have taken 3D Printer Training: Basics course.

Your trainer is: Richard Venzon. You can contact Richard through the Meetup Messages system or Slack. If you are having trouble contacting Richard, please comment below.

***Payment online is required no later than 24 hours before the start of the session ($36.75 includes GST). If you cannot pay online contact us to make alternate arrangements prior to the training session. If you are unable to attend the training and do not attempt to contact the trainer at least 24 hours prior to the start of the training, you will be liable for the full cost of the training. Exceptions will be made under reasonable circumstances.

Attendees (1)