Make your own as you will not get a ready made cable most likely.
It is not very difficult to make it.
RJ11 Pin 1 to DB9 Pin 1 ,RJ11 Pin 4 to DB9 Pin 5, RJ11 Pin 5 to DB9 Pin 3,
RJ11 Pin 6 to DB9 Pin 2
The pin numbers should be inside the DB9 cable.
If you need help building one I think a few of us here can help you
out if you get the parts.
On Wed, Aug 24, 2011 at 11:07 AM, hv <[address removed]> wrote:
> It's not clear what you are trying to connect.
> RJ-11 is four conductor; typically, it's used
> to connect to the phone system ("tip/ring" interface
> from Ma Bell).
> DB-9 is used /often/ for serial (RS-232) connections.
> It is a 9-conductor device.
> Are you looking for a cable for a 'standard' of
> some kind? Or is this a 'custom' pin/wiring
> On 08/24/[masked]:51 AM, Chris Vitale wrote:
>> I'm searching everywhere online.
>> Does anyone know of a good source where I can get an RJ11 to DB9 Cable?
>> I dont want to use the rj11 to db9 adapter. Im trying to minimize signal
> Please Note: If you hit "REPLY", your message will be sent to everyone on
> this mailing list ([address removed])
> This message was sent by hv ([address removed]) from NY Tech Meetup.
> To learn more about hv, visit his/her member profile:
> To unsubscribe or to update your mailing list settings, click here:
> Meetup, PO Box 4668 #37895 New York, New York[masked] |
> [address removed]
"Wise men talk because they have something to say; fools, because they
have to say something." Plato