addressalign-toparrow-leftarrow-leftarrow-right-10x10arrow-rightbackbellblockcalendarcameraccwcheckchevron-downchevron-leftchevron-rightchevron-small-downchevron-small-leftchevron-small-rightchevron-small-upchevron-upcircle-with-checkcircle-with-crosscircle-with-pluscontroller-playcredit-cardcrossdots-three-verticaleditemptyheartexporteye-with-lineeyefacebookfolderfullheartglobe--smallglobegmailgooglegroupshelp-with-circleimageimagesinstagramFill 1languagelaunch-new-window--smalllight-bulblightning-boltlinklocation-pinlockm-swarmSearchmailmediummessagesminusmobilemoremuplabelShape 3 + Rectangle 1ShapeoutlookpersonJoin Group on CardStartprice-ribbonprintShapeShapeShapeShapeImported LayersImported LayersImported Layersshieldstar-shapestartickettrashtriangle-downtriangle-uptwitteruserwarningyahooyoutube

RE: [mel-raspi-hackers] Garage monitor and advice on soldering

From: Trevor W.
Sent on: Sunday, February 12, 2017, 11:14 AM

Alec,

 

Thanks for this. Much appreciated.

 

Cheers,

Trevor

 

From: [address removed] [mailto:[address removed]]
Sent: Thursday, 9 February[masked]:52 AM
To: [address removed]
Subject: Re: [mel-raspi-hackers] Garage monitor and advice on soldering

 

 

On 9/2/17 11:23, Trevor Warren wrote:

 

I will admit that my soldering skills suck big time and while i would love to sharpen those skills i haven't had much opportunity. Rather that ruining the board i thought i would bring it along and get someone to help me out with soldering of the contacts. Anyone keen to assist...:) ?

 

Secondly, i picked up one of the single (non-replaceable) tip soldering irons from Dicksmith years ago. It gets the job done but isn't good for soldering in tight spots. Thoughts on how i might approach this would be appreciated...:)

 

 

This is a good resource on learning to solder

https://learn.adafruit.com/collins-lab-soldering

Advice on good soldering kit can be had on the CCHS mailing list (there is already probably a tonne in the archive)

Cheers



-- 
 
Alec Clews
Personal <[address removed]>             Melbourne, Australia.
Jabber:  [address removed]             PGPKey ID: 0x9BBBFC7C
blog:http://alecthegeek.github.io/





--
Please Note: If you hit "REPLY", your message will be sent to everyone on this mailing list ([address removed])
This message was sent by Meetup on behalf of Alec Clews from Melbourne Raspberry Pi Hackers (Jam).
To report this message, please click here
To block the sender of this message, please click here
Set my mailing list to email me As they are sent | In one daily email | Don't send me mailing list messages

Meetup, POB 4668 #37895 NY NY USA 10163 | [address removed]