Fab Lab Introduction Classes Monday March 7 12:00 pm and 4:00 pm

What is the cost?

The cost is $99.00 for Maryland Baltimore County residents and $104 for Maryland non-Baltimore County residents. The cost is approximately $149.00 for out of state students.

How do I register?

In order to register for this continuing education class go to http://www.ccbcmd.edu/ceed/reg.html and use the proper CRN# of the course you want to take - see below.

VOA 843
Fab Lab Introduction
Total Cost: $99 (Tuition: $50 Fees: $49)
CRN# Day/Ses. Dates Time Location
43818 M (1) 3/7 12-3:15pm CC
VOA 843
Fab Lab Introduction
Total Cost: $99 (Tuition: $50 Fees: $49)
CRN# Day/Ses. Dates Time Location
43820 M (1) 3/7 4-7:15pm CC Contact the Fab Lab Coordinator Bill Werneke at wwerneke @ ccbcmd.edu or 443-840-4401 if you have difficulty using the online registration system or have questions.

Directions:

The community college is located off of interstate 95 at exit 47B, which is about fifteen minutes (no traffic) south of Baltimore and one hour (no traffic) north of Washington DC.

After taking exit 47B you will be on 195 West and will be heading northwest. 195 West continues as the left part of a fork/"Y" you will come to. At this fork follow the sign that says 166 on it (this is a left at the fork). Do NOT take the right part of the fork/"Y" that says "UMBC Only" as the "UMBC Only" exit will take you to the University of Maryland Baltimore County (UMBC), not the Community College of Baltimore County, Catonsville (CCBC and UMBC are two different colleges and are located at two different campuses).

195 West ends at/runs into 166/South Rolling Road. You will still be traveling northwest while on 166/South Rolling Road. Once on 166/South Rolling Road look for Campus Drive (Campus Drive will be on your left and is opposite of Valley Road). Turn left onto Campus Drive when you see the sign for the Community College of Baltimore County, Catonsville (this blue sign also includes an electronic messaging display). You will be now heading southwest on a long curvy driveway and up a fairly large hill. When you come to another fork/"Y" in the road take a right. You will then be going counter clockwise on the "ring road" that encircles the CCBC Catonsville campus. Drive until you see the sign for parking lot number 5. Parking lot number 5 is the closest parking lot to building H.

The general physical address of the community college is 800 S Rolling Rd, Baltimore, MD 21228-5317. The Fab Lab is located in room H145 of building H on the Catonsville campus. A vertical sign in front of the building with an "H" also designates this building. This building also has a blue awning that says "Applied Technology Center" on it. Go in the door with the blue awning. There will be a short jog to the right once you go in this door. After the jog to the right the Fab Lab is at the end of the long hall and on the right side. The Fab Lab is across from a room that has air traffic control and flight simulators.

Buildings on this campus are well marked, but see the campus map for the exact location: http://www.ccbcmd.edu/directory/cat/camp_map.html . You can also find the lab on Google Maps by clicking http://maps.google.com/maps?f=q&source=s_q&hl=en&q=%22CCBC+MIT+Fab+Lab%22

Parking:

Park only in the spaces with white lines (parking in spaces with red, blue, or green paint stripes may result in your vehicle being ticketed). If you have to park in a parking lot that is a bit far from Building H, and you don't want to walk, you can ride a shuttle bus that runs during normal business hours.