Arduino Class - Using Stepper motors


Details
Come join us at TheLab.ms Education Center in Plano TX to learn how to use Stepper Motors on the Arduino platform. In this class we will be covering the following:
Stepper motors Part 1: Introduction (http://bit.ly/2hlv5v1) (7:30) This presentation will introduce you to stepper motors. In Part 1, I discuss the basics of stepper motors and their most typical configurations. All demo sketches are available on Github.
Stepper motors Part 2: Connecting a unipolar un-geared motor (http://bit.ly/2glYUhB) (11:30) In Part 2, you will learn how to wire up and use a unipolar un-geared motor.
Stepper motors Part 3: Controlling a unipolar un-geared motor (http://bit.ly/2hlEJ0P) (6:15) In Part 3, you will learn how to control the speed of an un-geared using a potentiometer.
Stepper motors Part 4: Connecting a unipolar geared motor (http://bit.ly/2gmaGbv) (5:00) In Part 4, you will learn how to connect a unipolar geared motor.
Stepper motors Part 5: Using the AccelStep library (http://bit.ly/2hlLG1V) (7:45) In Part 5, you will learn how to connect a unipolar geared motor and control it using the AccellStep library. Parts Needed:
Arduino UNO (http://amzn.to/2guHM9Z) stepper motors (http://amzn.to/2gPRP7l) L298N Motor Drive Controller (http://amzn.to/2hlstxa)
Course work for this class comes from Arduino Step By Step (http://goo.gl/5Uv71ft) which has over 20 hours of content in 110 lectures. These classes are designed for anyone interested in learning electronic design and C programming. No experience is required. Access to the course material is free at our meetups. If you wish to access the material outside the meetup see our coupons page to get a discount from our sponsor (http://www.hackerspacetech.com/pages/coupons.html).

Arduino Class - Using Stepper motors