Fusion 360 Workshop #1

***** NOTE: WE HAVED CHANGED THE DATE OF THIS WORKSHOP DUE TO INCLEMENT WEATHER******

*******THIS WORKSHOP REQUIRES REGISTRATION DUE TO SPACE CONSTRAINTS: ******

please register at the link below in addition to marking attending here:
https://mtras.com/events/145-fusion-360-workshop-1.html

Join Morgan as he discusses getting started with Fusion 360!

### In this workshop he will discuss:

1. The Fusion 360 work environment

• Folders and backups
• Views and manipulation
• Setup of units, grid vs no grid, preferences

2. Test part created 1st of 4 ways

• Extrude
• Dimensions using drag
• Dimensions using numeric entry
• Cut
• Cut one side, symmetric, two sides

3. Saving part – Version #
4. History bar

• Naming features
• Moving back and forth in time

5. Test part created 2nd of 4 ways

• Two circles extrude (all in one)
• Advantages and disadvantages of this method.

6. Test part created 3rd of 4 ways

• Introduction to reference geometry – Center line
• Revolve feature

7. Test part created 4th of 4 ways

• Square block to part.

8. 15 minutes of Q+A

### If Time allows, depending on pace of workshop

1. Radius and chamfer
2. Simple Drawing from part
3. Created mesh for 3d printing
4. Show part in Cura

### Recommendations for workshop attendance:

• This workshop is suitable for anyone wanting to get a quick start with Fusion 360 and maybe pick up some things you didn’t know.
• It is recommended that you bring a laptop with fusion 360 installed, and verified that the program will load and open. This is not required.
• We start on time.